Ive just got a hub puller from my granddad and have seen a hub somewhere for
#25 so I shall give it a go!
-----Original Message-----
From: ZoboHerald@aol.com [mailto:ZoboHerald@aol.com]
Sent: 06 May 2005 14:32
To: Jones Jarrod JCP; spitfires@autox.team.net
Subject: Re: FW: Pain in the...
In a message dated 5/6/2005 4:34:12 AM Eastern Daylight Time, "Jones Jarrod
JCP" <Jarrod.Jones@jobcentreplus.gsi.gov.uk> writes:
>
>This sounds quite a major thing now! Do you think it would be easier just to
>get a new complete driveshaft and all other bit that come on it, such as hub
>etc?
>My wheels seem fine as I do have the car up in the air at the mo. I actually
>belive that we unintentionally bent the hub when fitting the new diff!
======
Jarrod, if you can determine that it is just the hub that is bent, go ahead and
beg, steal or borrow the correct puller and change the hub for a good one. Of
course, if you happen across a good, complete used axle assembly, that's
probably as easy to swap in and does NOT require any special tools. ;-)
--Andy Mace
PLEASE NOTE: THE ABOVE MESSAGE WAS RECEIVED FROM THE INTERNET.
On entering the GSi, this email was scanned for viruses by the Government
Secure Intranet (GSi) virus scanning service supplied exclusively by Energis in
partnership with MessageLabs.
Please see http://www.gsi.gov.uk/main/notices/information/gsi-003-2002.pdf for
further details.
In case of problems, please call your organisational IT helpdesk
-----------------------------------------------------------------------
This document is strictly confidential and is intended only for use by the
addressee.
If you are not the intended recipient, any disclosure, copying, distribution or
other
action taken in reliance of the information contained in this e-mail is
strictly prohibited.
Any views expressed by the sender of this message are not necessarily those of
the Department
for Work and Pensions.
If you have received this transmission in error, please use the reply function
to tell us
and then permanently delete what you have received.
Please note: Incoming and outgoing e-mail messages are routinely monitored for
compliance
with our policy on the use of electronic communications.
The original of this email was scanned for viruses by the Government Secure
Intranet (GSi) virus scanning service supplied exclusively by Energis in
partnership with MessageLabs.
On leaving the GSi this email was certified virus-free
|