I have a large-size grease fitting (with a pipe thread) that "almost" fits into
the hole.
I remove the plug, screw in the grease fitting (not too tight), and grease it
up.
Then I put the plug back.
I guess you could also use a grease gun with a cone-shaped rubber tip.
Doug
At 08:18 PM 10/31/2004 -0600, you wrote:
>Hey Doug,
> When you take the rack off and try to clean every thing up, so you can put
>your new gaiters and tie rod ends on, what's the procedure for greaseing the
>works without a grease zerk on the pinion box?
>
>Larry
|