The aluminum shrouds can be purchased from PRI -- http://www.prirace.com
I may also have some drawings for the shrouds. If you are interested, let
me know and I'll look for them. Seems to me, I received them some time ago
from someone on this list.
Regards,
Ed Hamilton
-----Original Message-----
From: spitfires-owner@autox.team.net [mailto:spitfires-owner@autox.team.net]
On Behalf Of Chris Foster
Sent: Thursday, May 27, 2004 11:16 AM
To: spitfires@autox.team.net
Subject: Engine Compartment - Cardboard Panels
I've been following along reading about Anthony's issue with
over-heating and the possible solutions... Early on someone (I believe
Richard) mentioned the importance of the cardboard panels in the
spitfires engine compartment. Unfortunately when I got my spit, they
were all but torn out - leaving only the stubs along the bottom.
Granted I haven't had too much of an issue with over-heating, although
on a warm day, I often have the cabin heat on full to dissipate the
extra engine heat.
All that said, at one point I saw (somewhere online) that someone had
made a nice set of aluminum panels to replace their cardboard ones.
Does anyone have any thoughts on this? It would seem to me that
aluminum panels would allow for better heat transfer out of the
compartment than cardboard panels - only adding to their cooling
ability. With that said, the question then is:
a) Does that logic make sense, or are cardboard ones apt to be better?
b) If my logic is sound, does anyone have any form of drawings for these
panels that would allow me to create them? - Remember I only have the
stumps left where they bolt in.
thanks again for all help offered :)
c.
Chris Foster (cfoster@eppcon.com)
Project Coordinator / Software Designer
Eppcon Systems Inc.
3-57 Ashbridge Circle, Woodbridge Ont.
Tel: (905)265-7737 x240
Fax: (905)265-8837
Cell: (647)388-1905
www.eppcon.com
|