To go along with your findings on the upper perch. I didn't run
anything other than the upper perch, no rubber, not a washer...just the
spring directly contacted to the perches. I don't know what that would
do as far as ride quality to run without the rubbers as ride quality
wasn't my primary objective.
Aaron
-----Original Message-----
From: Larry Vaughan [mailto:lvaughan@pldi.net]
Sent: 23 December 2003 21:38
To: Aaron Johnson
Cc: spitfires@autox.team.net
Subject: Re: Spax dampers
Aaron suggested;
>Check and make sure that the lower seat is full nested. There always
>seemed to be an issue with that little plate seating correctly. The
>end coil could play a roll in the equation as well. Is the spring
>fully seating on the plate? I had a set of springs that the i.d. of
>the spring was slightly small and didn't fit the lower perch correctly.
>Do you have a picture of them with the springs on?
After some adjustments, I got the springs lined up and got pics also.
http://www.ljvaughan.homestead.com/spaxdampers.html
Larry
|