John,
A better way might be to use some rtv adhesive. That's what I did with both
the inner and outer seals. Didn't like the idea of gouging the fresh paint
down to bare metal which is what the clips will do. In fact, rtv replaced
clips in every area, from the front bonnet emblem to the rear valance. Works
great and eliminates a place for rust to start.
Good luck ... Ken C
> Can someone tell me the factory correct way to install
> the inner waist seals on a late 1500. It appears that
> the seal clips should engage the part with the bare
> metal portion down, however, I have seen this part
> installed with the bare metal portion up on several
> cars at a recent show. Does anyone have an un-molested
> example as a reference? Please advise.
> John Reynolds
|