Thank you for all your replies. All the advice was
helpful. Since I also wore out my throw out bearing I
have spent the last couple of days taking the engine
and out. (actually twice, the second because I for
got to check the alignment of the clutch connecting
rod)
This afternoon I took outthe new switch and took it
apart. Only the electricals are out. It looks like I
can swap them out no problem. Will know tonight or
early tomorrow. Keep a good thought out for me. I
can use all the positive thoughts there are.
Chris DeStaffany
> Chris DeStaffany wrote:
>
> >I am on the road,one thousand miles from home and
> my
> >ignition switch is on the fritz. Only works part
> time
> >if I wiggle it a lot. Had to hot wire the car to
> get
> >it going. I have ordered a new ignition switch
> from
> >BPNW that should be here tomorrow. Here's the
> >question. Can I just change the internals and how?
>
> >If no, how do pull out the whole switch?
> >
> >Any replys would be appreciated as I'm in a real
> >pickle this time.
> >
> >Chris DeStaffany from Friday Harbor Wa
> >currently at friends at Ridgecrest Ca
> >
>
__________________________________
The New Yahoo! Shopping - with improved product search
|