Going from memory here on my 1980, as the valences are no longer
installed.
The line has several clips on it, of the press through type. As in
attaching by having the clips being pushed through holes in the
valences.
>>> Roger Elliott <elliottr@rmi.net> 09/16/03 10:38PM >>>
Hi,
I just got some engine valences put on my 80 Spitfire. I had a metal
shop in town cut them to the paterns I had. The total cost was only
$25.00 for both sides! Anyway, I haven't had any on for a long, long
time.
My problem is, I can't figure out where the gas vapor line that runs up
to the charcoal canisters should attach. The line has one metal clip
around it. I am not sure if there should be more. If there is just
one
does it fasten with the same screw as the front of the valance?
Obviously, I could fasten it down anywhere I want, but I would like to
do it where it was originally.
-----------------------------------------------------
The information contained in this communication may be confidential, is
intended only for the use of the recipient named above, and may be legally
privileged.
If the reader of this message is not the intended recipient, you are hereby
notified that any dissemination, distribution, or copying of this
communication, or any of its contents, is strictly prohibited.
If you have received this communication in error, please re-send this
communication to the sender and delete the original message and any copy of it
from your computer system. Thank you.
-----------------------------------------------------
<<<<GWIASIG 0.07>>>>
|