Ok, now to figure out which axle it is :-)
thanks Joe and all!!!!!
Don & Henry
--- Joe Curry <Spitlist@gte.net> wrote:
>
>
> Henry Stike wrote:
> >
> > We are just getting ready to transfer stuff to new
> > spit 1500 frame and noticed that the radius arms
> are
> > different. On one side, measured from poly bushing
> to
> > frame (parrallel to frame,body off frame) 7&1/4
> in,the
> > other side is almost 9 in. Then noticed that one
> is
> > welded at almost 90 degree from bushing holder and
> the
> > other rod at about 80 degrees from bushing holder.
> So
> > big difference here. Can't figure out which one
> should
> > be correct. I think Henry had a real hard time
> lining
> > up one of the rad rods last rebuild.
> >
> > So we guess one of them is for a different
> spitty....
> >
> > Any help would be appreciated......
> >
> > Thanks,
> > Donald & Henry Stike
>
>
> The longer ones are for a later Spit with the longer
> axles. So if you
> have one of those, get a mate for the longer one.
> But if you have an
> early (short axle) Spit, get a mate for the shorter
> one.
>
> Joe
__________________________________
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|