the typical A/C system (installed in TR6's)
only used a two belt pulley on the water pump to run
the A/C compressor. At least to my knowledge....
only the MGB used a dual belt pulley down on the crank
to drive the A/C compressor. (Anyone need a system?
I've a complete setup 'with proper pulley for an MGB) :^)
Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: <elliottr@rmi.net>
To: <spitfires@autox.team.net>
Sent: Wednesday, May 21, 2003 2:16 PM
Subject: GT6 Crankshaft pulley
> I am getting ready (still) to rebuild my 68 GT6 engine. I plan on adding
an air conditioner to it. But, I will need to add a second belt. Anyone
know if there is another pulley that is made for two belts that is basically
a direct replacement? Perhaps a later GT6 or TR6 pulley?
>
> Thanks,
>
> Roger Elliott
> 68 GT6
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|