Doug,
----- Original Message -----
From: "Douglas Braun" <doug@dougbraun.com>
| Put it in fourth, push down the clutch, and see if you can turn the
| transmission output shaft.
The propshaft is connected... Im guessing thats going to be quite
difficult... I guess I can push the car... or someone else can.
| Look with a flashlight around the base of the slave cylinder,
| and see if you can see the pin moving forward when you press the clutch.
|
| Maybe the clutch hydraulic system needs more bleeding?
|
| I hope you didn't already install the tunnel cover!
|
Bleed it some more? I havent bled it... should I have? I didnt disconnect
any hydraulics...
One thing - when the slave cylinder was off - the clutch pedal didnt move -
almost like it was jammed - when I put it back in the clutch pedal started
moving again - is this normal?
Nope, its still off - I didnt want to put it back until I tried everything
out.
James
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|