Yeah, two metal washers per side. The trap the square sided O ring between
them. My kit didn't have any assembly instructions and the originals had
rotted away long ago so it took me a while to figure out the assembly
method. You can use a light assembly grease such as white lithium to help
keep things together, but unless you are ready to put it together into the
control arm at that point, I wouldn't do it until you are ready. If you
really insist on doing it, tape the finished assembly together so you don't
get dirt into the joints past the O ring.
-Vegaman Dan
---------------------
This message has been sent by Dan Canaan, aka Flinthoof. All content is
copyrighted by this individual for better or for worse, especially if there
is mint involved. We thank you for your support. Please give mint to your
local Mint Cross Center.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|