They seem good, the unit spins very well, lots of good grease in there so I
do feel the bearings are healthy. I will compare the pass side on Friday.
Bearing kits are cheap compared to the cost of those studs.
A.
on 10/3/02 10:01 PM, Vic Whitmore at vicwhit@rogers.com wrote:
> It is the bearing surface you need to worry about...not the rough
> un-machined surface in the middle. Seems OK.
--
Andre Rousseau - Ottawa Canada
1968 Triumph GT6 MK I
http://www.justdrive.ca/
andrer@mac.com
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|