Listers,
I forgot to mention that I had to take the case apart in order to drill a drain
hole and tap it for a plug. The gears have not been removed (I knew better
than that...). I marked the side drive shafts for Right and Left so they
wouldn't get switched around (per instructions in my Bentley manual.
I was surprised that the diff gasket was so thin - looked like waxed paper, not
a gasket, and that the side seal housing plates didn't have any actual gaskets,
just a dark orange goo to seal them up. But then, they aren't held in place by
a whole lot either, four allen head screws.
The pinion seal did seem a little dry and brittle, so I think it was a good
idea to check everything.
Again, thanks in advance for any advice.
Joe Guinan
--
_______________________________________________
1 cent a minute calls anywhere in the U.S.!
http://www.getpennytalk.com/cgi-bin/adforward.cgi?p_key=RG9853KJ&url=http://www.getpennytalk.com
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|