At 11:00 PM 7/11/01 -0700, Joe Curry wrote:
>Since everyone is so convinced that I should modify the beautiful "Finned
aluminum" oil pan, I am sending this to the list!
>
You didn't mention to the list that the engine had a finned aluminum pan.
Most folks like myself had to assume it was a simple stamped steel pan.
And even if it does have a finned aluminum pan, I'd still fabricate a new
out of sheet steel or aluminum. I agree, no need to modify a cast pan like
you may have on that engine.
________________________________________________________________________
| | 1968 Triumph Spitfire Mk III * Furry Artist |
| Flinthoof |--------------------------------------------------------|
| | MINTMINTMINTMINTMINTMINTMINTMINTMINTMINTMINTMINT!! |
| Dan |--------------------------------------------------------|
| Canaan | ConiFur NorthWest 2001 - Furries in Seattle! |
| |--------------------------------------------------------|
| CONIFUR NW | Flinters@picarefy.com * http://jarmac.picarefy.com |
|_____________|________________________________________________________|
/// spitfires@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe spitfires
///
|