Earl Smith wrote:
>
> Listers
> Recently i converted Kermit to a crane ignition system(XR700 and 40,000
> volt coil) my plugs were originaly set at .025 but iwas told that the gap
> should be increased to make full use of the higher voltage.Does
> any one have any suggestions as to what the gap should be increased to?
> TIA
> Earl and Kermit the 75 Spit
Earl,
I would think that the spark gap would depend not only on the new ignition
system but on the compression ratio of the particular engine. MSD provides
a guide with their units to suggest ranges of gap settings that correspond to
the various compression ratios of engines.
But I have the same Crane system on Huxley and have retained the stock gap
settings.
Joe
///
/// spitfires@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe spitfires
///
///
|