Larry,
Look at the two ends of the spring. See if one has the last two coils right up
against each other. If that describes your springs, that is what
Haynes is talking about. If the coils are all evenly spaced, don't worry about
which end goes against the head.
Joe
P.S. The set I got from SpitBits were the same on both ends!
Larry Elswick wrote:
>
> I just read in my Haynes Manual to
> install dual valve springs with the
> "close coils" next to the cylinder head.
> I don't understand. Would someone
> explain .Thanks!
> Larry
|