The oil seal is in the bellhousing on the gearbox side. The bolts that attach
the tranny to the bellhousing are inside the BH, so the whole trans/BH has to
come out. Be sure you remove the housing for the clutch slave cylinder also.
There is a kraft paper gasket between the gearbox and the BH. You will to
need replace that. There was an amazing amount of grease on the inside of my
bellhousing which, I presume, came from the gearbox.
Tom Burke
80 Spit
In a message dated 3/20/2001 8:54:11 AM Eastern Standard Time, A666K@aol.com
writes:
> All this trans. fluid talk has got me thinking about my own trans., to get
> the front oil seal swapped involves only bellhousing removal, correct?
> TIA,
> Avi
|