Paul,
Does the term, "DPO" mean anything to you? :)
Joe
Paul Tegler wrote:
>
> After disassembling 6 pairs of HS carbs, I've found that
> even
> the same cast part (number cast into part) IS NOT THE SAME.
>
> anyone having carb... running.... stumbling.... vacuum...
> problems, beware.
>
> I've found two sets now with the same part numbers,
> and they are not the same. One has a carb 'ported' vacuum
> tap, one doesn't and they have the exact same number on
> them.
>
> The inside 'port' that feeds the jet pipe at the bottom of
> the float bowls
> vary as well. I've found one is a small round hole rather
> than the
> 'square' sediment trap everyone is use to.
>
> The dashpot pistons... same story. The little dumbbell on
> the piston
> is different lengths as well (the little free floating piece
> on the
> end of the piston. 8103 and 8114 are suppose to
> differentiate
> this, but not so.
> This allows one to let the piston move father than the other
> before
> real 'damping' kicks in....
>
> I'm bummed... I could go on and on.
>
> No wonder everyone has so many problems, when not knowing
> what you're starting with.
>
> Paul Tegler ptegler@cablespeed.com
> www.teglerizer.com
>
> Paul Tegler ptegler@cablespeed.com
> www.teglerizer.com
|