Exactly! For drilling in the center of the light switch opening, just clamp
another board to the back and use a long pilot drill. When I did this I did
not use a drill press, I just was very careful to keep the drill square to
the work and went slowly.
Kevin Rhodes
Portland, Maine
Freddy the well-gauged Spit.
At 04:20 11/07/2000 -0500, OHFASTONE@aol.com wrote:
>Just a thought but,
>since you'd be using a hole saw with a pilot, couldn't you use the larger
>blade, watching how deep you cut, cut the recess grove then switching to the
>smaller blade, cut the opening since the pilot hole would still be remaining
>for the second step, the accuracy would remain?
>
> Michael
|