Yup,
you're right, the drain has a hex headed plug screwed
into it.
Carter
--- Joe Curry <spitlist@gte.net> wrote:
> Carter,
> Is the flat spot directly under the freeze plug or
> about an inch or so toward the front of the engine?
> The one closer to the front is
> where the blow-by pipe was capped off.
>
> Joe
>
> Carter Shore wrote:
> >
> > Not so fast, I'm looking at a 1500 block dangling
> from
> > the end of my lift, and there is no drain, only a
> flat
> > spot in the block casting where it should be.
> > Thanks, BLMC bean counters!
__________________________________________________
|