I could use the voice of experience here. I picked up an ABS transmission
tunnel cover for my 1980 Spitfire. The idea was to replace the "paper"
original cover (in excellent condition, other than being a bit thin for my
taste) Of course, it did not include a rubber seal.
Luckily, I found a "transmission tunnel seal kit" at
SpitBits. Unfortunately, the kit consisted of a roll of seal with nothing
else.
What is the ideal adhesive to use in gluing this type of rubber seal to the
ABS cover prior to installation? What works, and what have folks tried
that is a definite no-no? Has anyone attempted to transplant the
plastic-covered insulation that is attached to the paperboard cover over to
an ABS style cover?
Ron Deaver, aka Taliesin
New 1980 Spitfire owner, getting the proper baptism with lots of repairs
(full brake system replacement starts tomorrow...)
|