I started a set...back in '79. Never really finished the project.
Ended up using a '57 Chevy for the scheme (not in my control)
I use to work with a lot of the early raytracers.
Some could translate AutoCAD and 3D Studio files directly to the
vector text formats for the ray tracers.
I may still have the rough wireframe on disk somewhere around here.
I know I have final output shots of the fully bodied Spit somewhere here.
Paul Tegler wizardz@toad.net http://www.teglerizer.com
----- Original Message -----
From: "Jason Tilley" <jtilley@austin.rr.com>
To: <triumphs@autox.team.net>
Cc: <owner-spitfires@autox.team.net>; <spitfires@autox.team.net>
Sent: Friday, September 22, 2000 4:22 AM
Subject: AutoCAD / 3D studio files...
Just wondering if anyone out their has ANY AutoCAD / 3d related files for
the spit 1500, I'm seriously contemplating doing a engine swap and wanted to
play with it with AutoCAD. Also AutoCAD / 3d files of various engines.... I
figure this is a safer route than starting off with a blow torch...(Just
kidding).
thanks,
Jason.
p.s. what is the correct e-mail address to send to the list, I am starting
to presume that it is spitfires@autox.team.net, but the web page says
triumphs@autox.team.net... and the mail server re-directs everything under
owner-spitfires@autox.team.net.....
|