Rob,
The trick is to use a large screwdriver or some other device to force the
pieces apart while tightening the nut. That makes the ball
try to rub against the joint until the nut is tight enough to prevent it from
spinning on its own.
Joe
Rob Travis wrote:
>
> Hi all,
>
> After removing the ball joints on my 65 MKII, I can't get the new ones
> to stop spinning as I try to tighten the nylox nut. Is there a trick to this
> or worse yet... a special tool I must purchase?
>
> Thanks in advance,
>
> Rob
>
> 50 days to Triumphest 2000 and counting
> _________________________________________________________________________
>
> Share information about yourself, create your own public profile at
> http://profiles.msn.com.
|