Seems to me that for it to hold, you would have to ensure that the mating
surfaces were clean enough to eat off of. I have epoxied
panels underneath holes and filled over with body filler but never have used it
on any panels that had any stress on them.
That might be the key to whether or not it will hold!
I always use the axiom that states: When in doubt, DON'T.
Regards,
Joe
LT wrote:
>
> Has anyone tried the epoxy method of joining panels? I have been told
> twice in the last week that this is better/stronger than welding. I have
> to patch a fender and was wondering about it.
>
> Larry Ternowski
|