The header on the '68 I just picked up from fellow Lister Mike Nugent
has
a three piece header design. I'm not sure how the gaskets are used on the
joining piece if it uses one, which I assume it would. I'm surprised how
well they fit under the intake manifold and they will certainly dissapate
heat better than a cast manifold.
-Vegaman Dan
-68 Spit Without A Name.
________________________________________________________________________
| | Equinart Studios * Furry Artist * Model Railroader |
| Flinthoof |--------------------------------------------------------|
| *U* | MINTMINTMINTMINTMINTMINTMINTMINTMINTMINTMINTMINT!! |
| Y2K! |--------------------------------------------------------|
| | ConiFur NorthWest 2000 - Furries in Seattle! |
| |--------------------------------------------------------|
| CONIFUR NW | Flinters@picarefy.com * http://jarmac.picarefy.com |
|_____________|________________________________________________________|
|