Getting ready to put new u-joints in the rear axles and think that I may be
getting too particular. In one of the yokes, there is a casting flaw where
it was bored for the cap of the u-joint.
It's not on an edge, but rather in the center of the bore -- about 1/16" in
depth and running about 3/8" at its' longest point. I guess it was some
type of a void in the casting. What's the opinion of the list:
1. Ignore it and consider it not a problem
2. Fill the void with a JB weld type material and polish it smooth
3. Trash the yoke and get another
Regards,
Ed
|