Once you get the body off, I'd appreciate a shot of
the rear suspension/diff area.
Thanks
Carter Shore
--- "Michael D. Nugent, Ph.D." <nugentmd@gte.net>
wrote:
>
> > . . . I'm very curious about how it fit under the
> bonnet, since it looks like it's under the bonnet of
> > something already. Could you please elaborate on
> that for those of us who are fascinated by this
> project?
>
> Yes, it fits under an unmodified GT6 Mk3 bonnet.
> The engine picture shows by how much if you focus on
> the
> grey foam air dam at the very top of the engine - as
> little as an inch just forward of the carb along the
> sides of the hood bulge, and as much as about 3" in
> the middle of the bulge. The hood/bonnet itself
> forms the
> top of that "plenum" area. What I'm told is that
> this was done with a combo of stock GT6 and stock
> Buick
> engine mounts. I'll add a close up of the mounts
> this weekend.
>
> There's also been a request for a photo of the
> exhaust manifold - I'll add that over the weekend,
> too.
>
> Any other requests for pics? I'll always add them
> to the site rather than putting them in email.
>
> --
> Mike
> Renton, WA
> >>----------> 914 Lite 2.5 is FOR SALE:
> http://home1.gte.net/NugentMD/914lite.htm
>
>
__________________________________________________
Kick off your party with Yahoo! Invites.
http://invites.yahoo.com/
|