In a message dated 8/3/00 8:26:35 PM Eastern Daylight Time,
spitfire@shelby.net writes:
> Did I make the cut for the gaskets? Just wondering, because I had asked and
> I saw that someone had already received theirs.
I wanted to try as small a group as possible to make sure the fit was OK,
well I got this message below, so all will have to wait a bit more.
In a message dated 8/3/00 9:32:35 PM Eastern Daylight Time, jmcneal@ohms.com
writes:
> I tried the 1/16th inch version and found it to be too thin.
So its off to 1/8 material acquisition and then cut.
|