Man I am going to pull the little bit of hair that I have left out !!!
I have had a problem with the pressure warning switch, I removed the guts
and plugged the cross over piece.
I did this due to the oddball thread size and also to keep the " Original "
looks. So what I have is a big aluminum coupling. No leaks and it flows
unrestricted.
The problem is, I can't get the front to bleed. I have a mini vac unit and
the rear does just fine.
When I put the vac on the front I get NOTHING ! I have NO pedal.
I am wondering if the front part of the Master has gone bad ????
I need to remove and bench bleed the whole cylinder ?
I need to buy a repair kit ?
Us a hammer with about 8 good blows to ADJUST it ?
HELP
Craig Smith
36 Pelham Ridge Drive
Greenville, SC 29615
800/692-2323 ext. 2105
864/234-1020 fax
e-mail: craigs@iewc.com
|