>This the reply to my inquiry about a rear hub puller as advertised on the
>VTR Classified.
>
>Tom,
> This tool was only recently fabricated. To work properly, I found that
>additional machine work was needed as well as 4 spacers made up -
>so a slight increase to $85 was necessary. ($95 w/shipping)
> It has been tested on several hubs and performed beautifully.
>It is beefier than the factory toll and has enormous strength - without any
>risk to the hub itself.
> (Allow 2 weeks for fabrication).
> Cordially,
> Phil Doumas
> 760 Pinetree Rd
> Pgh, PA 15243
>
|