I think you may be referring to the slots in the two cylindrical gadgets
that hold the bearing carrier. If I remember correctly, there is a
relatively shallow slot with a square bottom and a slightly deeper slot
with a rounded bottom. The pin goes in the shallow square bottom slot and
the bearing carrier goes in the deeper round bottom slot. Are these the
slots that you are referring to? If not then, I agree with Joe, I don't
remember any other difference.
I just did this on my 80 and a few months ago on my son's 72 and that is
what I remember.
Sam
At 10:43 AM 7/15/2000 -0500, Roger Elliott wrote:
>Hi,
>
>A friend of mine has been rebuilding my overdrive and transmission. He
>asked about the pins that hold the clutch release bearing mounting hub.
>Which way do they go? Does the roll pin through the narrow slot or the
>wide slot?
>
>Thanks,
>
>Roger Elliott
>
|