If I were a betting man, I'd bet that it will. The only way I know to get the
sand out is to blow compressed air into the holes and
gradually blow it all out.
By the way, the frame isn't nearly as bad as the body in collecting large
amounts of silicon!
Joe
Edward Hamilton wrote:
>
> My GT6 frame is about ready to go to the sandblaster. The ends of the frame
> are "capped" off. So, should I assume the frame will come back with 20+
> pounds of sand inside it? I doubt that I should expect the blaster man to
> remove it, so...how do I go about getting it out or should I attempt to plug
> all of the bolt/misc. holes first?
>
> Regards,
> Ed Hamilton
|