Xould it be that you have a stub axle on one side from an early short axle
spitfire and one from a later long axle on the other?
Cheers
Tim
M Klish wrote:
> I recently pulled the rear axles on my ?74 spit to replace wheel bearings
> and stub shaft bearings. After re-assembly, the axle on one side extends
> about 3/8" further from the hub than on the other side. Obviously, the
> re-assembly can not continue until I resolve the problem. I used factory
> spec bearings, and axles ends look OK. Any suggestions?? Anyone with
> similar experience??
>
> Thanks!!
>
> MWK
>
> ________________________________________________________________________
--
Tim Dafforn
Structural Medicine
Department of Haematology
CIMR
University of Cambridge
Wellcome-MRC Building (Level6)
Hills Road
Cambridge
CB2 2XY
Tel. (01223) 336829
Fax. (01223) 336827
http://smokeroom.cimr.cam.ac.uk/
|