I use an air body saw available from harbor freight for about 30 bucks. You
will need a mig welder to weld the pans in. That is a little more pricey,
1500 bucks for one that will work. You should have someone do it for you if
you do not have a mig. Pop rivets are temporary.
-----Original Message-----
From: owner-spitfires@autox.team.net
[mailto:owner-spitfires@autox.team.net]On Behalf Of Chris Pappathopoulos
Sent: Monday, July 10, 2000 9:57 AM
To: spitfire
Subject: floor pan removal
I plan to start working on removing my rusted out floorpan. I have a
full pan for the drivers side and the cross member. What is the best way
to remove an old own? I'd assume plasma cutter, but I don't have one
available to me. What would be next best? Any other advise besides
measure twice and cut once?
Thanks
Chris Pappathopoulos
|