Hi, Simon.
I just finished putting mine in this evening. Pipe runs alongside
frame rail around the side of the shock bracket, then up and over into
the three-way. If you have access to the factory workshop manual, the
picture on p. 3.202 is an excellent representation.
You will need a short-handle end wrench (spanner) or a "crow's foot"
to tighten the nut in the three-way. Too little space to get it tight
without.
Donald.
> From: simon.halliwell@postoffice.co.uk
> Date: Fri, 7 Jul 2000 08:55:15 +0000
>
> Hi,
>
> I'm in the process of finishing the rolling chassis for my '67 Mk3 Spitfire
>and
> I need to know how the brake pipe is supposed to run to the rear 3 way
> connector.
> I've got as far as down the L/H side of the chassis and I can't figure out how
> it get behind the vertical shock absorber/body mounting bracket, does it go
> around the side, underneath or over the chassis and then down under the L/H
> axle?
>
> Anyone any ideas?
>
> Thanks,
>
> Simon.
> Spitfire Mk3 1967
> Chesterfield
> UK.
|