Terry - the stock GT-6 disk diameter is quoted as 9.7 inches (24.64 cm) and
all three sets of them that I have are that diameter. I guess it has been
the policy over the years to "stretch" the diameter by .3 of an inch to make
it sound better.
Good luck on the project
John Tones, Victoria BC
'69 MKIII Spit (in the attic)
'71 GT-6 MKIII undergoing frame off resto
'78 1500 Spi, my son's daily driver
----- Original Message -----
From: "Terry L. Thompson" <tlt@digex.net>
To: <spitfires@autox.team.net>
Sent: Saturday, May 20, 2000 10:27 AM
Subject: GT6 Rotors
>
> As most of you are well aware, I'm upgrading the front rotors to GT6
stock.
> (I'm awaiting the verticles, bearings and such.) This seems like such a
big
> boon doggle, but it was time for new rotors anyhow. And after inspecting
the
> new rotors, I'm a bit confused by the diameter. I thought that GT6 rotors
> were 10", and these measure approximately 9.5" (give or take a 10th of an
> inch)
>
> Would someone do me the favor of measuring their GT6 rotors and let me
know
> what they get? I want to make sure I have the right part so when the rest
of
> the stuff gets here, I've got everything set.
>
> Terry L. Thompson
> '76 Spit 1500
> Maryland
>
|