Jeff,
To get the thing up higher, Jack it as high as your jack will go, place your
stands. Then lower the jack and put a wood block on top
and jack it up some more. Repeat the process until the car is sitting on the
stands at the desired height.
Joe
P.S. Use the frame cross members (front and rear) for jacking.
Jeff McNeal wrote:
>
> Hello fellow Spitfire fans!!
>
> The weekend has arrived and I'm getting ready to replace the seal on my oil
> pan (again, but this time with Permatex 2 on both sides of the gasket
> instead of dry). The last time I changed out the gasket, it was a pain in
> the neck because I didn't have enough room to crawl around under there. My
> floor jack reached it's lifting limit well before the jackstands reached
> theirs.
>
> I was planning on placing a 2 X 4 or a 4 X 4 under the front and rear cross
> frame cross members when jacking to apply the weight distribution more
> evenly and to gain another 2"-4". Anything wrong with this plan?
>
> BTW, up until now, I've been using the differential to jack up the rear --
> the PO's used the frame and I see where it's filled with all kinds of little
> dents from previous lifts. Anything I should be concerned with, there? The
> frame is straight -- just dinged up a little. TIA
>
> Best wishes,
>
> Jeff in San Diego
>
> '67 RHD Spitfire Mk3 aka "Mrs. Jones"
> Jeff's Classic '67 Spitfire Mk3 site & Vintage Spitfire Webring
> http://www.ohms.com/spitfire/spitfire.shtml
> home of the NEW Totally Triumph Auction
> "By Triumph enthusiasts, for Triumph enthusiasts"
> http://www.ohms.com/cgi-bin/TRauction.cgi
> and... The Triumph Autos/Parts Wanted Listings
> http://www.ohms.com/cgi-bin/TRwanted.cgi
> ...plus a few other surprises!
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
|