It is as easy as this...
Car up on ramps......the filler plug is accessible from under the car.
(Just!) ....remove the plug.....insert a piece of poly tube into the hole
and route it into the engine bay.....squeeze the oil down the pipe using the
oil bottle or a large syringe until gear box is full.......lower car to the
ground to get the correct level of oil.....raise the car to replace the
plug.
Dean Rayner
>
> Actually I have put fluid in both of my spits and my GT6 without removing
> the tunnel. It is not easy and you definitely need to get the car up on
> stands or a lift, but it can be done.
>
> Sam
>
> At 10:39 AM 4/25/2000 +0100, Dean Dashwood wrote:
>
>
>
>> Mark, I was surprised to not see an answer to this one (maybe I just wasn't
>> looking hard enough?) but in case you're still looking for it, yes you do
>> need
>> to pull the tunnel, once you do the filler plug is clearly visible.
>>
>> Dean
|