At 08:36 AM 4/17/2000 -0400, Bowen, Patrick A RP2 wrote:
>Dan, I just did this yesterday. you need 5/16 inch X 2inch long fine thread
>bolts (24 TPI). If your engine stand is similar to mine (arms are about 1
>inch thick) Here is another problem that should easily be overcame. The
>Spit engine was too small for my engine stand. Expect to drill new holes in
>the arms of the stand aboout half way out to save you some trouble.
>Otherwise you can not get the arms in close enough to bolt on to. (actually
>there is a way, but it will cause interference with other stuff (i.e. the
>crank) and is a pain.
Good info to have. I'm surprised it only needs to be that short, but if
it works. :) I'm always thinking that the bellhousing bolt holes just
don't look strong enough to hold the block but it works on heavy V-8's, so
why not?
________________________________________________________________________
| | Equinart Studios * Furry Artist * Model Railroader |
| Flinthoof |--------------------------------------------------------|
| *U* | MINTMINTMINTMINTMINTMINTMINTMINTMINTMINTMINTMINT!! |
| Y2K! |--------------------------------------------------------|
| | ConiFur NorthWest '99- Furries in Seattle! |
| |--------------------------------------------------------|
| CONIFUR NW | Flinters@picarefy.com * http://jarmac.picarefy.com |
|_____________|________________________________________________________|
|