>I'm reassembling my rear axle hubs today, and in the Haynes manual
>it says that the inner (roller) bearing should be installed by
>tapping on the lettered (not radiused) side. Fine. But from which
>direction is one supposed to tap?
>
>Maybe a better way to ask is ... which direction should the letters
>ultimately face -- in toward the diff or out toward the hub?
>
>
>Anybody else buy the d*mn VB u-joints that include a 3/4" long
>grease zerk? Well, the zerk interferes with the travel of the
>joint. Anybody see a problem with simply removing the grease zerk
>until it's time to grease again?
>
>Dan Buettner
Sorry folks -- might help if you knew what kind of car! This is on a
'77 Spit 1500.
Dan
|