In message <0.542d1e36.256e8ae2@aol.com>you write:
>
>I've fabricated an accelerator cable bracket for HS4's out of 3/16" aluminum.
> The bracket bolts onto the intake manifold using the two threaded holes
>provided there. The angle of the bracket is approximately 40 degrees up from
>horizontal.
>
Does it look anything like this:
http://www.ece.concordia.ca/~dave/carpics/e5.jpg
I had to make a similar bracket for my HS2 setup.
Dave |\ | | |
Dave Chu \/ \/ | /| | |
Dept. of Elec. & Comp. Eng. |/ | | |
Concordia University Voice:(514)848-3115 Fax:(514)848-2802
1455 de Maisonneuve W. H961 Email:dave@ece.concordia.ca
Montreal, Quebec, Canada H3G 1M8 http://www.ece.concordia.ca/~dave/addr.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|
