To quote from Kas Kasner's Competition Preparation Manual " The oil feed
holes to the end main bearings are kept stock, but since the center main
oil
hole feeds two rods, it is drilled out to 5/16"
Ralph
----- Original Message -----
From: Roger Elliott <relliott@cjnetworks.com>
To: RALPH JANNELLI <RALPH.JANNELLI@Prodigy.net>
Sent: Thursday, September 23, 1999 12:03 AM
Subject: Re: Oil coolers and rocker feeders
> This is slightly off this subject. But when I first bought my Spitfire,
it had
> a blown engine. I talked a lot with the local British car shop guru. He
told
> me before I even tore the engine apart that either number 3 or number 4
main rod
> bearings would be the trouble.
>
> He was right - they were both spun. Anyway, in the course of having the
engine
> block prepared he told me that within a short time after introducing the
1500
> engine Triumph sent out a TSB saying that if the engine was rebuilt the
oil
> galley feeding those bearings should be enlarged as the galley didn't
provide
> enough oil to deal with the added stress of being a 1500 instead of a
1296.
>
> The interesting thing is, even though they recommended doing it whenever
doing a
> rebuild they never enlarged the galley in original production,
>
> Roger Elliott
> 1980 Spitfire
|