>My vote goes to it being a half-shaft U-joint. When I was running my Spit as
>a daily driver, I went through them about every 2 years. Symptoms were light
>tick tick, that over time became heavier tock tock, then became a repair
>bill.
Here is a good test for these joints:
1: Put the top up, and you can hear it better
2: Coast about 20-25 mph in neutral and do some gentle S-turns
3: If the noise gets louder when you turn left, it's the left joint, etc.
4: If you turn the opposite direction, the noise should almost disappear
if you turn just the right amount.
5: If the noise doesn't change when you turn, maybe they're both bad...
6: If you apply power, the noise should go away (because you are loading up the
joints).
The cause of this noise is the side load imposed on these U-joints,
which causes the joint to go "click-click" as it slides back and forth
sideways. The axle shaft normally exerts an upward force on the differential.
As you turn, the side load on the wheel can increase this force or neutralize
it,
depending on which way you turn. To visualize all of is, think of the axle
shaft
as a lever, with the suspension joint at the hub being the fulcrum, and the
wheel exerting an upward force a few inches further down the shaft.
It takes very little endplay to allow this to happen-
If you try poking and prying at the joint, it may seem fine. A while
back somebody described how the fitting of thicker circlips or shims could
fix this problem.
I do not think this is a big safety issue; if the joint gets truly worn out
or damaged (e.g. cracked or siezed needles) it would make really evil sounds.
One of mine is clicking, but I am too lazy to get all tired and filthy
crawling under the car right now to fix it...
Doug Braun
'72 Spit
|