James, good point.
When I installed new roll bar bushes on my car, I laid it on the ground,
and it WAS a bit out of level.
I simply swapped sides when I re-installed it. Perhaps in another 20 years
it will be level once again!
Atwell "Optimist" Haines
'79 Spitfire
Succasunna, NJ USA
At 12:36 AM 6/18/99 +0100, James Carpenter wrote:
>Don't forget problem up front. I've noticed it on my car, the anti role bar
>bends! Lower on the drivers side, (RHD in my case) remove it and my car
>sits level (even when I have my warn old spring)! Put the bar on a level
>ground an you will notice one end higher. A spring shop should be able to
>streighten it for you and retemper it!
>
>Infact I would sugest replaceing that plastic bit, and streightening the
>antirole bar, new bushes for it. Then a new rear spring if its showing its
>age. Folowed by air shocks if all that fails.
>
>Remember that the swing spring has almost know antirole propertys, and you
>have that huge bar up front trying to stop the lean. The anti role bar has
>a huge influance.
>
>
|