OK, it's my turn. . .I remember a while back a discussion about what lube
to use when installing poly bushings to prevent squeaking/groaning (the
car, not the person installing them :-). I was planning on using a moly
lube, actually assembly lube since it contains anti-sieze and moly. These
are poly bushes from BPN, not Nylatron or other such material. I heard my
Spit do a terrible groan, and clunk while pulling out of the Post office
yesterday and upon inspection, the rear lower trailing arm bush
disintegrated and the bolt/sleeve was riding on the A arm itself, so you
know what I'll be doing this weekend!! Well I admit, it has been a long
time since I replaced them. Any pros/cons on using this particular
lubrication??
Barry Schwartz (San Diego) bschwart@pacbell.net
72 FI, V6 Spitfire (daily driver)
70 GT6+ (when I don't drive the Spit)
70 Spitfire (long term project)
|