I got a couple suggestions that I check that the wires were on the right
plugs. Yes they are correct. I checked that several times myself because
it seemed like a plausable solution, sorry I should have included that
tidbit. I even compared the position of the rotor to the valves to be sure
they were in sync, they were of course.
I just checked the rotor and cap and found a little corrosion on the cap
terminals. A touch of sandpaper and all four cylinders lit up! It's still
pretty rough running so I'm going to go ahead and change out the rotor,
cap, wires, and maybe even the coil. It's amazing how you can get a spark
with a tester but not enough current to lite up a spark plug. I'll chock
that up as a learning experience. Lord knows I have had a lot of learning
experiences with these wonderful cars.
BTW, my other car ('73 Spitfire) passed inspection yesterday!! Woo Hoo,
I'm legal again.
Forever a student,
David Gates
Hawaii
>X-Sender: dgates@pop.lava.net
>X-Mailer: QUALCOMM Windows Eudora Light Version 3.0.3 (32)
>Date: Mon, 17 May 1999 12:37:29 -1000
>To: spitfires@autox.team.net
>From: David Gates <dgates@lava.net>
>Subject: Firing on only one cylinder
>Sender: owner-spitfires@autox.team.net
>Reply-To: David Gates <dgates@lava.net>
>X-Info: To unsubscribe send mail to majordomo@autox.team.net with nothing but
>X-Info: unsubscribe spitfires
>X-Info: in the body of the message
>
>
>List,
>
>In the last week or two I finally found some time to work on my second
>Spitfire ('78). I'm starting to find myself rather stuck on this one
>though. It starts but is extreemly rough, then usually quits within 5-10
>seconds. It appears that only the number 1 cylinder is firing. The other
>three exhaust pipes are cold and the plugs are wet. All 4 plugs are
>sparking according to the little spark tester (looks like a sparkplug with
>a clear body so you can see the spark). The engine I pulled from a
>different car ('76) and has not been running (correctly) in the '78 yet,
>but it did run in the '76. Sometimes when it quits a port on the front of
>the ZS carb angled at a 45 degree angle upward shoots a small burst of
>exhaust smoke. This really tripped me out. I have never seen a carb do
>that. I know that my manifold gasket needs replacement bacause there is
>some exhaust leakage comming from there. I just don't see how a small leak
>in this gasket could cause 3 cylinders not to fire at all.
>
>Despite the fact that I have spark on all four wires, I am a little suspect
>of the distributor. Mainly because it is different from the one originaly
>on the engine. It is electronic, the original was points. I think I will
>get a kit for it (rotor, cap, wires) and see if that helps any. I will
>also put a new manifold gasket on. Apart from that does anyone have any
>other ideas that might help out?
>
>Thanks as always,
>David Gates
>Hawaii
>
>
|