I went down to Pep Boys and found a roll of insulation with foil backing
and some 3M spray on adhesive. I glued it down to the underside of the
tunnel with the foil side toward the gearbox and I sealed all of the edges
with black silicone calk. It works great! I havn't had any problems and
the heat and noise are a thing of the past. The silicone is very important
though. Without it, the foil will come loose because of wind and oil.
**********************************************************************
Ray Bryant
Keller, Texas
'73 Spitfire 1500 (FM6879U), Daily driver
Red River Triumph Club http://www.imagin.net/~hensley/rrtc.html
Bryant Studios Photography http://www.flash.net/~photoray
**********************************************************************
|