At 07:52 AM 3/22/99 -0500, coliver@mail.arl.mil wrote:
>
>I replaced the missing seal on the header of my Spitfire factory hardtop and
>can not get it back on. I have the correct spacers in the header rail. The
>problem is the top will not sit down in the front. I end up with a good 1/4
>inch gap where you can see the seal between the top and the top of the
>windshield. Is this right? This top has become such a pain I have even
>considered selling it! Thanks Chris
Chris,
It has been said that Spit windshield frames can be bent down if a driver
lifts him(or her)self out of the car by pulling on the windshield. Could
this be the source of your gap, rather than a problem with the top?
Does the angle of the side window and the windshield frame match?
Just a thought,
Atwell Haines
Succasunna, NJ USA
"Despite the cost of living, have you noticed how it remains so popular?"
|