The slinger was used in the early non-synchro units of the 60's
Yours should have a seal in the bell housing, unless you fitted an early
bellhousing...
Let me know...
Clark
In a message dated 1/29/99 9:05:07 AM Pacific Standard Time, mgrazian@ltcm.com
writes:
> > My gearbox has been leaking down the front shaft (in the bellhousing)
> > since I reinstalled it. I took the bellhousing off and the bearings are
> > wet, but there is an oil slinger in there that's supposed to throw the
> > oil back. All the parts catalogs list an oil seal and an o-ring that go
> > on/in the bellhousing. I don't have either of those. The catalogs say
> > that the seals were only installed after a certain model of gearbox, and
> > I am assuming mine must be one of the early models. My question is, can
> > I fit the oil seal and o-rings to my transmission, and if so, should
> > that stop the leak? Thanks!
> >
> > adrian
> >
> > --
> > -----------------------------------
> > J. Adrian Barnes
> > adrian@icx.net
> >
> > http://user.icx.net/~adrian/midget
> > http://www.ravineware.com
> > -----------------------------------
>
|