OK, I'm taking apart the rear axles and I have run into a problem.
Somebody out there must know this:
Ok, I have removed the axle hub.
Now, according to the directions, I push the inner hub down the axle shaft
to expose the outer bearing so I can remove it. Here is my problem, the
axle is machined so that the inner hub can only go down the shaft a certain
distance. With the inner hub pushed down the shaft as far as it will go, I
can not get to the far side of the bearing to remove it. Wassup??
question:
What is the proper way to dismantle the rear axle so I can replace all of
the oil seals and check the bearings??
thanks.
----------------------------------------------------------------------------
Huw Upshall Email:
@home: hupshall@wolfenet.com
@work: hupshall@microsoft.com
http:
@home: www.wolfenet.com/~hupshall
'Misspelled? Impossible! My modem is Error-Correcting!'
----------------------------------------------------------------------------
|